Skip to content
Amigari Downs Lock ExpertsRequest a visit
Open 24/7(365) 607-0483Call now
Person holding a long metal door-hardware assembly beside a cart of similar parts and a glass door fitted with a push bar. — Panic & Exit Hardware, Fort Erie

Plan ahead Commercial · Fort Erie

Panic & Exit Hardware

A padlock went on the stockroom's back door years ago for security and nobody has thought about it since, until the walkthrough this week pointed out that the same door is the room's only other way out.

Call now · open 24/7(365) 607-0483

Request a visit

In plain words

A pair of doors is its own small project, and not every pair needs the same approach. Some rim-device pairs keep their mullion and latch each leaf independently with no set closing order. Where sequencing does matter, one leaf is chosen as the inactive leaf and closes first, guided by a coordinator so the active leaf's device can seat properly into the strike or into an astragal on the inactive leaf. Removing a centre mullion calls for a compatible replacement arrangement on each leaf, which can matter for wheelchair access or for moving equipment through.

Sound familiar?

Two doors used to swing as a pair at the community hall entrance, but one leaf has started closing before the other, catching the astragal and leaving a gap wide enough to worry the caretaker.

How the visit goes

Panic & Exit Hardware · Fort Erie

How the visit goes

Illustrative locksmith scene
  1. 1

    Checking what is already fastened to the door

    A surprising number of exit-hardware calls turn up a second lock nobody had mentioned: a hasp and padlock added for security, a slide bolt at the top of a rarely used door, or a deadbolt installed long after the original exit device. Each of these has to be understood before work starts, because an exit door can only be trusted to open under one motion if every fastening on it releases the same way. The locksmith notes what is there, explains what it means for the door's exit function, and works out with the owner what stays and what comes off.

  2. 2

    Handling a pair of doors

    On a pair, a coordinator is fitted only where the hardware needs the leaves to close in a set order, letting the active leaf's device seat into the strike or into an astragal carried on the inactive leaf; many pairs latch independently and skip this step entirely. Where the plan calls for one wide exit instead of two narrow ones, the centre mullion is removed and vertical-rod devices are fitted to each leaf instead, arranged so both close and latch reliably. Either way, both leaves are tested together, not only on their own, before the visit is called finished.

  3. 3

    Room to grow into the next change

    If the space changes use again, adds seating, or the occupant load creeps upward with a future renovation, the hardware fitted now is already suited to a use that requires it, rather than something that will need revisiting the moment the room grows busier. Keeping a note of the occupant load the current hardware was specified for means a future change can be checked against that number before it becomes an inspector's finding rather than a planned upgrade.

In the van

  • Astragal and mullion hardware
  • Dogging key or keyed cylinder
  • Outside trim (pull, lever or cylinder)
  • Through-fixings and mounting hardware
  • Door closer

What affects the quote

  1. 1

    Door and frame condition

    A door that has sagged, a frame that has shifted, or a strike pocket that no longer lines up needs correcting before hardware is fitted, which adds its own line to the quote.

  2. 2

    Electrified functions added

    A request-to-exit switch or electric latch retraction adds wiring, a power source and coordination with the building's other systems, while a standalone alarm module can run on its own battery; each is priced alongside the mechanical installation itself.

  3. 3

    New preparation or existing cut-outs

    A door with no prior hardware needs new holes cut and reinforced to the device's template. A door already prepared for a similar device, even an old one, is often a simpler fit with less new drilling.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(365) 607-0483

Panic & Exit Hardware: questions

Advice · (365) 607-0483

What does the finished installation actually prove to an inspector?

It proves that a specific device, rated for the opening it sits on, releases under an appropriate force, latches fully, and has been tested and recorded on a given date. The record travels with the building, so a fire inspector reviewing the space later is looking at a documented history of that exit rather than testing hardware with no known installation date or specification.

Can I add a request-to-exit switch for my access-control system?

Yes. A request-to-exit switch is wired to signal the access-control panel that the pushpad or crossbar was actuated. Telling that apart from a forced or propped door usually means pairing it with a door-position contact and the panel's own logic, since the switch on its own only reports that the hardware was used. It sits alongside the mechanical device without changing how the crossbar or touchpad works, so the door still releases under a push even if the access-control system loses power.

Can a padlock or extra deadbolt stay on a door that has this hardware?

No additional fastening should stay on an exit door that does not release the same way the primary device does. A hasp, padlock or separate deadbolt added at some point for extra security is a common finding on an older door, and removing or replacing it with something that releases under the same push is part of bringing that opening back to a single, reliable exit.

Niagara, Ontario

Fort Erie information

Town
Fort Erie, Niagara, Ontario
In business
26 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

62%

Older homes. About 62% of homes in Fort Erie were built in 1980 or earlier, according to the 2021 Census.

Decades of seasons move a frame, and an older house often has a front door that locks easily in summer and fights in winter. Setting the strike with the seasons in mind, and choosing a lubricant that stays fluid in the cold, keeps it working year round.

83%

Mostly houses. Single-detached houses make up about 83% of homes in Fort Erie (2021 Census).

A detached house gives a locksmith room to work: full access to both sides of every door, hinges and frames included. Repairs and upgrades can be thorough, from the front deadbolt to the gate latch, with nothing off limits.

Source: Statistics Canada, 2021 Census of Population

Open Fort Erie in Google Maps

Open 24/7

Request a visit

A padlock went on the stockroom's back door years ago for security and nobody has thought about it since, until the walkthrough this week pointed out that the same door is the room's only other way…

Call now · open 24/7(365) 607-0483
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 26 years in business